Insulation Below Code Level
Older roofs often carry less insulation than a replacement must add under the energy code. Added polyiso brings it up to the required level.
Greenup County · Across From Portsmouth
South Shore Commercial Roofing Contractor
Set Edge Metal and Insulation to the Kentucky Code Line
As a South Shore commercial roofing contractor, we replace roofs to Kentucky rules, even when materials or crews come from the Ohio side of the river.
Kentucky Rules
South Shore Commercial Roofing to the Kentucky Code
Kentucky rules guide every job for a South Shore commercial roofing contractor. South Shore sits across the river from Portsmouth, Ohio, but its roofs follow Kentucky rules. It is a Greenup County city, and building questions go to the city office or the County Judge Executive.
That matters when material or crews come from the Ohio side, because edge metal, coping, and insulation are checked against the Kentucky code. We confirm the required insulation value before anything is ordered.
- Kentucky Building Code for the roof
- 2012 IECC for commercial energy, per DHBC
- South Shore city office or Greenup County
- Insulation thickness set to the Kentucky level
- Coping reset at the new roof height
- Roof access doors checked for clearance
Roof Conditions
What South Shore Roofs Need at Replacement
A full replacement brings several parts of the roof up to the code in force.
Short Parapet Flashing
Added insulation leaves old wall flashing too short above the new roof. Taller wall flashing fixes it.
Curbs Too Low After Taper
Rooftop unit curbs may need extenders to stay high enough over thicker insulation. Curb extenders keep units high enough.
Edge Metal at the Old Height
Gutters and edge metal move up to meet the new roof surface. New edge metal and gutters match the height.
Door Thresholds to the Roof
Doors onto the roof get checked so the new surface does not rise past the sill. Raised curbs or sills keep doors clear.
Worn Membrane
Aging sheet with split laps is what usually starts the replacement conversation. A new membrane replaces it.
Benefits
Benefits of Reroofing Your South Shore Building
A South Shore roof built to Kentucky rules passes inspection and works as one system.
- Edges
Built to the Right Code
Materials and details are checked against Kentucky rules, whatever side of the river they come from. Inspection goes smoothly as a result.
- Deck
Insulation at Code Level
The roof gets the insulation the commercial energy code calls for at replacement. More polyiso also keeps the deck warmer.
- Curbs
Details Raised to Match
Curbs, flashing, and edges rise with the new roof height. Nothing ends up below the new surface.
- Seams
A New Sealed Membrane
Old split laps are replaced by one new welded or taped sheet. Laps are probed or rolled as they go.
- Edges
Roof Doors Still Open
Thresholds and door curbs are raised with the new roof, so roof access doors keep clearing the surface. Doors keep opening onto the roof.
Our Services
Commercial Roofing Work in South Shore
South Shore work is mostly low-slope commercial roofs, with some metal buildings.
TPO Over Code Insulation
Welded white sheet over insulation brought to the Kentucky level. Coping height is checked too.
TPO RoofingFull Flat Roof Replacement
Tear-off with edges, curbs, and flashing raised to the new height. Taper is added at the drains.
Flat RoofingEPDM Replacement
Rubber sheet on simple roofs with walls flashed to the new height. T-joints are patched every time.
EPDM RoofingMetal Building Roofs
New panels with insulation set to the energy code. Vapor retarders go on heated space.
Commercial Metal RoofingMaterial Coming From Ohio?
It still gets checked against Kentucky code. Tell us the building and we confirm the insulation level and edge details first.
- Kentucky code applied
- Insulation level confirmed
- Heights measured
Process
How a South Shore Commercial Roofing Contractor Builds to Code
Code questions are answered before material is ordered.
Inspect Your Roof
We measure current insulation, parapet, curb, and threshold heights against the new roof build-up. Those numbers set the build-up.
Confirm With the City
The South Shore city office or Greenup County confirms the permit and the insulation value required. We get the value in writing.
Build Up the Roof
Insulation, cover board, and membrane go down, with curbs and edges raised to match. Edges rise with each section.
Raise Curbs and Flashing
Unit curbs get extenders and wall flashing gets more height, so every detail clears the thicker roof. Extenders go on while units are off.
Inspect and Walk
Details are walked against the permit before the job is photographed and closed. Then the inspection is called.
Commercial Roofing
Find Your Town Near South Shore
We take commercial roofing work in South Shore and the towns below, eleven places in all. Outside them? Call us or send us a message.
South Shore
Kentucky code roofs across the river from Ohio.
- AshlandHome base for the service area
- RussellRiverfront roofs where wind hits edges first
- FlatwoodsStorefronts and offices where rooflines meet zoning
- CatlettsburgDamp river air at the Big Sandy mouth
- RacelandTear-offs timed to dry stretches
- GreenupCounty seat shops, barns, and storage
- GraysonRetail and office roofs on state permits
- Olive HillState-issued permits, skylights, and hatches
- WorthingtonCity line beside Raceland to confirm first
- LouisaBig Sandy drainage at low roof edges
Questions
Affordable South Shore Code and Roof Answers
More answers are on the commercial roofing FAQ.
Code
Do South Shore roofs follow Kentucky or Ohio building rules?
Kentucky rules. South Shore is a Greenup County city, so the Kentucky Building Code applies, along with the 2012 IECC for commercial energy as listed by DHBC.
Edge metal, coping, and insulation are checked against the Kentucky code.
Permits
Who issues permits for a South Shore reroof?
The South Shore city office or the Greenup County Judge Executive, per the state Greenup County contact sheet.
Insulation
Does a full replacement need more insulation?
Usually. A full replacement brings the roof under the commercial energy code, which often means more polyiso than the old roof had. Confirm the value with the permit office before ordering.
Heights
What changes when the roof gets thicker?
Edge metal and gutters move up, parapet flashing needs more height, unit curbs may need extenders, and roof door thresholds are checked.
Materials
Can we use materials bought in Ohio?
Yes, as long as the system and details meet Kentucky requirements for the job. The code that applies is set by where the building stands.
Inspection
What gets checked when a South Shore roof is inspected?
The inspector looks at the details the permit describes: insulation thickness, edge metal, coping, and flashing heights at walls and curbs.
We walk those details against the permit before calling for the inspection, so nothing has to be reopened.
Recover
Can we recover instead of tearing off in South Shore?
Only when the old roof is dry and there is one existing roof on the deck. Kentucky code limits recovers over wet or multiple roofs.
Core cuts settle the question, and the permit office confirms it before materials are ordered.
Hire a South Shore Commercial Roofing Contractor
Send the address and roof size. We check insulation and edge heights before quoting.